Product Dimensions: D9.8"(25cm) x H59"(150cm)
Material: Alabaster Marble, Brass
Finish: Black
Light Source: Integrated LED
Dimmable: Upon Request
Lumens: 110 lm/W
Voltage: 90-260VAC
Installation Type: Corded Wall Plug
Certifications: UL, CCC, CE, CQC, EMC, FCC, GS, LVD, PSE, ROHS, SAA, and VDE

Details

Placement: Table and floor lamps are designed for free-standing use on stable surfaces such as floors, side tables, desks, or patios. Always position lamps away from high-traffic areas to avoid tipping.
Power Source: Models may be powered by a corded wall plug, built-in rechargeable battery, or solar panel. Refer to the product description to confirm the power type.
Indoor/Outdoor Use: Not all models are weather-resistant. Confirm the product’s rating before using outdoors.
Dimming: Some lamps include built-in dimming switches or are compatible with plug-in dimmers. Refer to product specifications for details.
Bulb Compatibility: If your lamp uses replaceable bulbs, always use the recommended type and wattage.

Tools You May Need

• None required for most models
• Optional: screwdriver (for battery cover or shade assembly)
• Optional: extension cord (for outdoor or distant wall outlets)

Installation Steps

Step 1: Unpack and Inspect the Lamp
Carefully remove the lamp from its packaging. Check for any visible damage or missing components. If your model includes a detachable shade or base, follow included instructions to assemble them using hand-tightened fittings or a simple screwdriver if necessary.

Step 2: Choose a Suitable Location
Place the lamp on a flat, stable surface where it won’t be easily knocked over. For outdoor use, ensure the surface is dry and level. Keep the lamp clear of water sources unless it is explicitly rated as water-resistant or waterproof.

Step 3: Connect the Power Source

• For corded models, plug the lamp into a nearby wall outlet. If using outdoors, be sure the plug and outlet are weather-protected.
• For battery-powered models, check if the lamp already includes pre-installed batteries or if they are provided in the packaging. If needed, open the battery compartment (typically located at the base or underside of the lamp), insert the specified battery type, and securely close the compartment.
• For solar-charged models, position the solar panel in direct sunlight for best performance. Initial full charge may require several hours of daylight.

Step 4: Install or Check the Bulb (if applicable)
If your lamp includes a replaceable bulb, screw it in gently, ensuring it is seated properly. Do not exceed the maximum wattage listed on the socket label. Integrated LED models do not require bulb installation.

Step 5: Turn On and Adjust
Use the on/off switch, touch sensor, or remote (if included) to power the lamp. Adjust brightness levels or modes if your model includes dimming or lighting presets. For outdoor solar or motion-activated lamps, full function may begin after a full charge cycle.

Important Tips

• Always follow safety warnings printed on the lamp or in the manual.
• Do not use indoor-only lamps in exterior settings.
• For battery-powered lamps, replace or recharge batteries as needed to maintain performance.
• For solar models, periodic cleaning of the panel improves charging efficiency.
• Unplug corded lamps during lightning storms or long periods of disuse.

Need help?

We’re here to assist with setup, compatibility, or warranty support.
Contact us at: help@residencesupply.com